Muskoka MFI2500 Guide d'utilisation et d'entretien Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
Grounding Instructions
This heater is for use on 120 volts. The cord has a plug as shown
in figure A in the diagram. An adapter as shown in figure C is
available for connecting three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug extending from the adapter must
be connected to a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a three-slot grounded
receptacle is available.
Locating Your Insert
It is safe to set the fireplace insert close to non-combustibles. DO NOT
STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR
LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
Specifications
MFI2500
Masonry Insert
Dimensions W x D x H
24" x 10.8" x 19.5"
61cm x 27.4cm x 49.5cm
Net Weight
Gross Weight
22 lbs / 10 kg
25.3 lbs / 11.5 kg
Voltage
120 V
Frequency
60 Hz
Watts / Amps.
1400 W / 11.6 A
Heater Rating
4770 BTUs
Electrical Connection
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance.
Preferably, the fireplace insert will be on a dedicated circuit as other appliances on the same circuit
may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes
standard with a 6 ft (1.8 m) long 3 wire cord, exiting out the back of the fireplace insert. Plan the
installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum
14 ga, 3 wire with grounding type plug and connector and rated not less than 2025 watts. The extension
cord shall not be more than 20 ft (6 m) in length.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations
to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this masonry fireplace insert if any part of it has been under water. Immediately
call a qualified service technician to inspect the firebox and replace any part of the electrical system
which has been under water.
2
Fig. 1
Grounding Pin
Cover of Grounded Outlet Box
A
B
C
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
Vue de la page 2
1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire